Paul,
Thank you so much for the input.. As luck out have it, I discovered that 
"%code" a few minutes after I sent my question to the group.  It seemed 
odd that my tower computer loaded the GPS the way I wanted and the 
Laptop did not load them correctly.  I had been playing with the screen 
you mentioned for an hour or so and did not see the difference until I 
had the same screen up on both computers.  It's all better now.  Thanks 
again,
Bob Smith

Paul Ross wrote:

> Robert
>
> After you click send to gps, you arepresented with a screen. On this 
> screen under 'waypoint name' it should read '%code' yours probably 
> says '%name'. Great peice of software. Use it for both the garmin 60CS 
> and my trusty Magellan Gold.
>
> Hawk
> Team RedHawk
>
> Robert & Linda Smith wrote:
>
>> Dear Group,
>>
>> I have been using the GSAK software to load my GPSr's with all that 
>> neat waypoint stuff and all the degrees, minutes stuff and it has 
>> been working fine for a long time.... Upgraded the laptop to version 
>> 1.2.6 and I can not figure out why the software loads the cache name 
>> instead of the waypoint name like it used to..  Any of you 
>> programmers out there have an idea???
>>
>> Bob Smith, Petite Elite
>
____________________________________________________________
Az-Geocaching mailing list listserv@azgeocaching.com
To edit your setting, subscribe or unsubscribe visit:
http://listserv.azgeocaching.com/mailman/listinfo/az-geocaching

Arizona's Geocaching Resource
http://www.azgeocaching.com